Cosen AH-250H, Instruction Manual

Page: 54 / 134

OPERATING INSTRUCTION
Section 4
4-21
STEP 5 & 6
5 .Press and hold the REAR VISE BACKWARD
button until the rear vise moves to the backward
limit.
6 . Loosen the lock lever at the top of each
vertical roller, and move by hand the vertical
rollers wider than the width of the work to be
loaded.
STEP 7
7 .Gently place the work between the rear vise
jaws. Project the end of the work by about 50
mm(2 in.) from the front end of the rear vise
toward the front vise.
STEP 8 & 9
8
. Press and hold the REAR VISE CLAMP
BUTTON TO CLAMP THE WORK.
9 . Move the vertical rollers close to the work by
hand, and tighten the lock lever of each vertical
roller.
4.7 PROCEDURES TO STOP AN OPERATING PROCESS
STOP
Manual cutting operating:
•
To stop the cutting operation, please press the BLADE UP button, or HYDRAULIC OFF button.
•
The saw blade stops running when the BLADE UP button is pressed. The saw blade and hydraulic
pump motor both stop running when the HYDRAULIC OFF button is pressed.
•
When an error occurs, the machine automatically stops, please refer to section 9 for troubleshooting.
Automatic cutting operating
:
•
To stop the cutting operation, press the BLADE UP button or HYDRAULIC OFF button.
SAW BLADE
WORK
PIECES BACKWARD
LIMIT
ABOUT
50mm(2in)
WORK
PIECES
WORK
PIECES
Page 54 Instruction Manual for AH-250H (B040) 04/12/2014