Cosen AH-250H, Instruction Manual

Page: 23 / 134

MOVING AND INSTALLATION
Section 3
3-1
SECTION 3
MOVING AND INSTALLATION
3.1 INTRODUCTION
Your machine is made of three main system components: Machine equipment, hydraulic
system, and electrical control system. Please read the entire manual carefully to obtain a thorough
knowledge of the machine. This section describes how to move and install the machine to prevent
personal injuries and machine damage. Do not operate the machine by guesswork. Keep the manual at
hand and refer to it whenever you are not sure of how to perform any of the procedures.
3.2 MOVING THE MACHINE
When moving the machine, we strongly suggest that you follow the carrying and cleaning
methods described to keep your machine in the best working condition. You can choose any one of the
methods described below to move your machine:
Carrying :
1. Use crane to place
Carry the machine to its designated location by using a crane and a wire rope sling that can fully
withstand the weight of the machine. Apply the wire rope sling to the lifting hooks at the rear of
the front vise slide and to the rear end of the machine. Slowly lift the machine while taking care
so that the machine is not shocked and that the wire rope does not interfere with the saw-head.
•
To move your machine with a crane, you
must have a crane‘s qualification license.
•
You must use tools and equipment with the
proper tensile strength and use proper method
when moving your machine.
Page 23 Instruction Manual for AH-250H (B040) 04/12/2014