Cosen AH-250H, Instruction Manual

Page: 35 / 134

OPERATING INSTRUCTION
Section 4
4-2
Have high cooling effect Remove paint
Not flammable Lose rust protection effect when deteriorated
Economical Foam
Does not require cleaning of cut
products
(especially when soluble)
Putrefy
Decline in performance, depending on quality
of water used for dilution
NOTE: Never work with pure water only.
If Shell Dromus BS or Shell Lubricool Yellow Cutting Fluid is used, the ratio of cutting fluid to water
should be approximately 1liter:15liter ~ 1liter:20liter. Check the sight gauge to ascertain the fluid level
in the tank.. Tank maximum capacity: 38 liters(10 gal.)
4.3 CONTROLS DESCRIPTION AND OPERATION
Here we briefly describe the control panel, manual mode, automatic mode and identification
of failure condition.
4.3.1 Control console
Control Console Illustration
The control console is setting on top of left side of electrical box. In figure 4-1 is show all of
switch or/and botton position, therefore operator must understand each switch or/and botton function
before staring machine.
The illustration of the control console is shown in the following figure and there are 15 functional
gears on this control panel.
Fig 4-1 : Control panel Console
No. NAME OF ITEM No. NAME OF ITEM
01 POWER “ON” BOTTON 06 QUICK APPROACH BUTTON
02 POWER “OFF” BUTTON 07 VISE CLAMP SELECTOR
03 AUTO / MANUAL SELECTOR 08 REAR VISE FORWARD /BACKWARD SELECTOR
04 BLADE DRIVE BUTTON 09 SINGLE / BUNDLE CUTTING SELECTOR
05 RAISE BUTTON 10 COOLANT PUMP SELECTOR
11 WORK LAMP SWITCH 14 FEEDING TIMES SELECTOR
12 CUTTING PIECE COUNTER 15 BLADE SPEED DISPLAY
Advantage Disadvantage
Page 35 Instruction Manual for AH-250H (B040) 04/12/2014