Cosen AH-250H, Instruction Manual

Page: 46 / 134

OPERATING INSTRUCTION
Section 4
4-13
Blade Guide
3) After adjusting the position of the blade guide, tighten the lock handle to lock the blade guide
securely.
NOTE: When tightening the lock handle, gently swing the lower end of the blade guide
alternately to the left and right so that the dovetail is properly aligned.
4) Turn the left insert knob CW (clockwise) to tighten left insert.
5) Loosen the wing nuts and slide the safety cover out of the driven wheel cover, and tighten it
with the nuts.
6. When performing the single-cutting, remove the multi-vises using the following procedures:
1) Disconnect the multi-vise hoses.
2) Loosen the lock nuts and remove the multi-vise.
3) Remove the stud bolts.
Lock Nut Stud Bolt
7. Properly place the workpiece on the work feed table using the following procedures:
1) Depress the raise button to raise the saw blade until it is at the highest position.
2) Manually disengage the pawls from both the front and rear vise racks, and fully open the front
and rear vises.
Pawl
3) Loosen the lock handles of the vertical roller guides and fully open the vertical roller guides.
Page 46 Instruction Manual for AH-250H (B040) 04/12/2014