Cosen AH-250H, Instruction Manual

Page: 49 / 134

OPERATING INSTRUCTION
Section 4
4-16
actual cutting. Adjust the cutting fluid flow with the control levers according to the workpiece to
be cut.
Fluid Flow
Control Lever
•
If the saw chips are sharp and curved, increase the flow of cutting fluid.
•
If the saw chips are grained, reduce the flow of cutting fluid.
.........
........
..........
...........
.........
........
...
..
.
....
....
NOTE: Before depressing the blade drive button, insert the cleaning hose nozzle into the wire
brush case.
To determine the value to be set on the cutting length preset counter, be sure to use the following
equation:
l - t ( n - 1 )
C =
n
where, C: Value set on counter(mm)
l : Required cutting length(mm)
t : Set with 1.6(mm)
n: Feeding times
Example: When the required cutting length is 600 mm,
600 - 1.6 x (2 - 1)
C =
2
= 299.2 (mm)
Bundle Cutting
To perform bundle cutting, use the multi-vise and proceed as follows:
1. Install stud bolts on the front and rear vises, and position the multi-vises on the front and rear vises.
Page 49 Instruction Manual for AH-250H (B040) 04/12/2014