Cosen AH-250H, Instruction Manual

Page: 38 / 134

OPERATING INSTRUCTION
Section 4
4-5
|
“ ON” mode The coolant pump operates and the coolant supply begins.
|
“
OFF” mode The coolant pump halts and the coolant supply stops.
11.
WORKLAMP switch
“ ON” mode The work lamp operates.
“ OFF” mode The work lamp shut down.
12.
CUTTING PIECE counter
This cutting piece counter is used to present the designated cutting pieces while the machine is in
the AUTOMATIC CUTTING MODE (
).
It preset the number of cuts required in the automatic
mode. When the counter reaches the preset number, the machine stops automatically.
Fig 4-2 Cutting piece counter
The lower number (yellow color digital number) stands for the number of designated cutting pieces
while the upper number (white color digital number) is the number of workpieces which have been
cut in current automatic cutting period.
NOTE :
The PRESENT BUTTON (GEAR)is used to adjust the under number to the designated
cutting pieces.
After the counter reaches the number of designated cutting pieces (under number), the upper
number should be reset to “00000” by depressing the RESET BUTTON to get in the next
automatic cutting period.
13.
COUNTER “ON / OFF”switch
|
“ ON” mode When the switch is turned to this mode, the “CUTTING PICECS COUNTER”
is turned “ON”.
Page 38 Instruction Manual for AH-250H (B040) 04/12/2014