Cosen AH-250H, Instruction Manual

Page: 39 / 134

OPERATING INSTRUCTION
Section 4
4-6
|
“
OFF” mode When the switch is turned to this mode, the “CUTTING PICECS COUNTER”
is turned “OFF”.
14
. FEEDING TIMES selector
Depress the “
–
” type button at top or at under side for number changing. When this selector is
pressed to “2” the rear vise performs a double (two-times) feeding of the workpiece. On this
selector, the maximum cutting length is 3600 mm(141.7 in.) [400 mm x 9]. In addition, if cutting
length is 1200mm, then the feeding times should be set to “3”. The maximum feeding times are
“9”.
Fig 4-3 Feeding Times seletor
15
. BLADE SPEED display
The blade speed is shown here and the blade speed can be adjusted by stepless cariable speed
mechanism.
NOTE:
The B.S.D (blade speed display) all of data setting by COSEN Machinery Industrial Co.,
Ltd. Therefore operator must understand DO NOT CHANGE ANY PARAMETER
DATA BY USER.
Fig 4-4 Blade speed display
No: Name Remark No: Name Remark
1 Display Nb. Red LED 6 Millimeters unit light
2 Reference Nb. Green LED 7 Inches unit light
3 Setting key 8 Switching key
4 Number change key 9 Enter key
5 Increase key 10 Decrease key
Table 4-1 Discription of BSD
Ref.Nb. Function Contents Remark
1 Docimal point
0→0 / 1→0.0 / 2→0.00 / 3→0.000
Page 39 Instruction Manual for AH-250H (B040) 04/12/2014