Operating Instructions
Insulated Conductor Rail System
SinglePowerLine Program 0813
BAL0813-0007-EN
www.conductix.com
translated document
page 10 of 108
To be worn for
special tasks
When carrying out special work, special protective equipment is recommended. Separate
reference to this is made in the individual sections.
Protective eyewear
For eye protection against harmful influences such as strong light, chemicals, dust, splinters or weather
effects.
Hearing protection
For protection against loud noises and to prevent acoustic trauma.
Breathing mask (FFP3
—
according to country-specific requirements)
For protection against materials, particles and organisms. In this case, for protection against the dust
produced by the sliding contacts and the insulation of the conductor rail.
2.4
Intended use
The product is designed and built exclusively for the usage described here (intended use).
WARNING!
Hazard due to unintended use!
Any application that deviates from or goes beyond the intended use of the product can result in
hazardous situations.
→
Strictly follow all information in these operating instructions.
→
Refrain from unintended use of the system.
→
Respect the instructions on unintended use in Section 2.5.
Claims of any kind due to damages from unintended use are excluded.
The operator bears sole liability for all damage that results from unintended use.
Intended use
The SinglePowerLine 0813 Conductor Rail System is an operating resource for the customer to set up an electrical power supply
system indoors and in protected outdoor areas, in areas that are not accessible to the public. The conductor rail is an operating
resource and thus has no actual operating mode since this is determined by the application. Risks are limited only to the failure of
mechanical components (e.g., falling components) and the danger from electrical current.
The SinglePowerLine 0813 Conductor Rail System is used to supply electricity to mobile electrical consumers.
A typical use is, for example, in the area of bridge and process cranes.
Use other than in the application approved by the manufacturer must be examined by the system engineer as part of a risk
assessment for the final product and is under the responsibility of the system engineer.
An extended approval by the manufacturer for the application is possible in certain cases and requires written approval after
examination of the use case and ambient conditions.
Compliance with these technical conditions is mandatory for the installation:
◼
The maximum travel speed is up to 600 m/min depending on the system (straight line without interruption).
