Operating Instructions
Insulated Conductor Rail System
SinglePowerLine Program 0813
BAL0813-0007-EN
www.conductix.com
translated document
page 47 of 108
→
If the conductor bar is sawed, the cutting direction must be kept from top to bottom (see Fig. 44).
NOTE!
Maintain the cutting direction for the conductor bar!
If the cutting direction from top to bottom is not maintained, the rolled-in stainless steel strip will
loosen in the conductor bar.
→
Always adhere to the cutting direction!
Fig. 44: Note the sawing direction for the conductor bar
→
Saw the insulating profile accordingly. It must always be 2x92.5 mm shorter than the conductor bar.
Fig. 45: The insulation profile is shorter than the conductor bar
→
Chamfer the conductor bar on the contact surface with approx. 1-2 mm 45° to ensure a perfect passage of the sliding contact
over the rail joint.
→
Remove all burrs from all sharp rail edges and also deburr the insulating profile, e.g., with a smooth file (see Fig. 46).
9 2 ,5 m m
9 2 ,5 m m
