COMPRO TN65, User Manual

Page: 10 / 76

2-4 Digital I/O Connector Block LED Status Indicator
Compro TN65/TN65W Network Camera
LED Status Indicator
The instant you power on the camera, it automatically starts the booting procedure. There are one blue LED
and one red LED inside the camera casing. Depending on the booting status, the LED indicator will be lit in
the following way:
1. About 25 seconds after powering on the IP camera, both the blue LED and red LED indicator will become
lit (appears purple).
2. About 35 seconds after powering on the IP camera, the red LED will be turned off.
3. Camera trying to connect to network: both blue & red LED flashing at an interval of 0.5 second.
4. Camera established connection: blue LED constantly on (Red LED off)
5. Camera failed to connect: flashing red LED. (Blue LED off)
Red LED Blue LED Indication
On On System booting up
Off On Successfully established network connection
On Off Performing hardware test
Off Off Powered off
Blinking (every 0.5 sec.) Off
Failed to connect to network / failed to
establish a WPS connection
Off Blinking (every 0.5 sec.) Attempting to establish a WPS connection
Off
Blinking (every 0.2 sec.
in a 3-second period)
Successfully established a WPS connection
Blinking (every 0.5 sec.) Blinking Attempting to establish network connection
Table 1-1. LED status
Table 1-2.
Figure 1-3. Normal connection