WebConfig configuration
Control Station Duetto
38
1.7/1217
Digital Output #1
and
Digital Output #2
Controlled by
: In this drop-down list, the mode to control the digital outputs of DUETTO can be
selected. The following modes are available:
Intercom
: The digital output is controlled with ICX commands.
Logic Rules
: The digital output is controlled with logic rules (
).
Add-on Output
The optional USB output module EB1A provides an additional relay output for the DUETTO device. It
can only be controlled with logic rules.
STATUS
: Shows the current status of the relay output.
Click on the button
APPLY
to save the settings.
ATTENTION: Outputs has to be activated in CCT 800
The respective output of the DUETTO device has to be activated in CCT 800 at
Subscriber >
Station
Properties
> EE 980/bctone >
tab
Outputs
! Further information about output config-
uration in CCT 800 can be found in the manual “
Intercom Server Configuration
”!
GOOD TO KNOW: Control digital outputs in the classic Intercom mode
Required Intercom Server firmware version
: PRO 800 6.0 or higher
Required CCT 800 version
: CCT 800 6.0 or higher
The digital outputs can only be controlled in the classic Intercom user mode on the DUETTO
device (
NOTE: Further information
For further information about the configuration of ICX commands, see manual “
ICX Protocol
”.
GOOD TO KNOW: How to use the add-on output?
Connect the USB output module to an available USB port of the DUETTO device.
Go to:
CONFIGURATION > USB
in the WebConfig.
Make sure that the status “Plugged” is indicated for the USB port to which the USB output module
is connected (
). If the USB output module is recognised by the DUETTO device, the
section “Add-on Output” is indicated at
CONFIGURATION > DIGITAL OUTPUTS
in the
WebConfig.
Go to:
CONFIGURATION > LOGIC RULES
in the WebConfig.
Create or edit an existing logic rule, select the action “Digital Output” and the entry “Add-on Output”
in the drop-down list
Output
in order to control the relay output with any event (
NOTE: Further information
For further information, see datasheet “
EB1A
”.
1.4
