Calibration
6-4
Chapter 6: Configuration
98-150471-A02
2. Select the desired heading input.
3. Click
Apply
.
4. Select the desired position mode.
Figure 6-3: Web interface: SETTINGS, Navigation (Heading and Position)
(example)
Heading mode
Description
External
Heading input from the vessel’s gyro compass (default).
If there is no heading input due to failure, alarms are raised and the
antenna continues in gyro-free mode. When heading input is available
again and a new acquisition is made, alarms are cleared. See also
Fixed
Use this setting for making an azimuth and cable calibration if there is no
input from the vessel’s gyro compass and for permanent installations like
remote areas or oil rigs, or during training and test.
For
Fixed
, enter the vessel heading in degrees
Important: Fixed heading is not allowed for sailing vessels!
None I
mportant: You must make an azimuth and cable calibration
with Fixed before you can use this setting. This is required in
order to be able to use blocking zones. After a successful
azimuth and cable calibration you must change the heading
input setting from Fixed to None.
Select this setting after a successful azimuth calibration with Fixed
heading if the system does not have input from the vessel’s gyro
compass. See also
Table 6-1: Heading mode options
SAILOR900HP.book Page 4 Monday, July 18, 2016 12:44 PM
