98-150471-A02
6-1
Chapter 6
Confi
guration
Configuration
6
This chapter is organised in the following sections:
•
Introduction to the built-in web interface
•
•
Configuration with the web interface
•
•
6.1
Introduction to the built-in web interface
6.1.1
Overview
Use the built-in web interface (installation of software is not necessary) of the SAILOR 900
VSAT High Power ACU to make a full configuration of the SAILOR 900 VSAT High Power
with the correct VMU, the satellite positions you intend to use and other parameters. You
can use a standard Internet browser.
For quick start instructions see
6.1.2
Connecting to the web interface
To connect to the web interface of the ACU do as follows:
1. Power up the SAILOR 900 VSAT High Power system, i.e. switch on the ACU. Wait until
the LEDs on the front plate of the ACU show that the system is ready to be configured.
• Power LED: Green
• Logon LED: Off
• Fail/Pass LED: Flashing green, during power-on self test, after that steady green.
Connect a PC to LAN interface 3 (Service port, standard Ethernet) at the rear panel of the
ACU or to the front LAN connector of the ACU.
Important
The SAILOR 900 VSAT High Power system is not designed to be connected
directly to the Internet. It must be connected behind a dedicated network
security device such as a firewall.
If any ports of the SAILOR 900 VSAT High Power are exposed to the Internet
you must change the default passwords as anyone with access and malicious
intent can render the SAILOR 900 VSAT High Power inoperable.
SAILOR900HP.book Page 1 Monday, July 18, 2016 12:44 PM
