List of ACU events
G-10
Appendix G: System messages
98-150471-A02
0806E-0
ADM ERROR
VMU reference
signal
There is no VMU Rx or Tx reference signal.
Whether this is Rx or Tx reference depends on the
user's selection on the modem profile page in the
web interface. Make sure the VMU Rx/Tx cable is
connected and that the VMU is configured to
output the RX/TX reference signal.
0806F-0
ADM WARNING ROSS
synchronization
The ACU has become out of sync with the ROSS
device, most likely because the ACU has been
replaced, or the ROSS satellite profile is new. A
manual (forced) handoff sequence must be
initiated from the ROSS, refer to the ROSS manual.
08073-0
ADM WARNING Slave connection
The system is configured as a dual antenna master,
but no dual antenna slave is connected to it. Either
disable the dual antenna master in the web
interface or configure a another system as a dual
antenna slave.
08074-0
ADM WARNING Master
connection
The system is configured as a dual antenna slave,
but it was not possible to connect to the dual
antenna master. Check that the IP address entered
in the modem profile is correct and check that the
master and slave systems are physically connected
as described in the manual.
08076-0
ADM WARNING Incompatible
message version
The system is configured as a dual antenna system,
but the software versions on master and slave
system are different. Ensure that both master and
slave have identical software.
08078-0
ADM WARNING VMU TX
frequency invalid
The satellite modem provided a TX frequency of
zero. This may degrade tx performance. To remove
this warning re-configure the modem to provide
the correct tx frequency.
0807A-0
ADM WARNING Automatic
azimuth
calibration
pending
Automatic azimuth calibration mode is enabled.
The system tries to perform an azimuth calibration
using the target satellite whenever satellite data is
received from the modem. After successful
calibration the feature is automatically disabled
and the system returns to normal operation.
WARNING: If a system has not completed azimuth
calibration after the installation, the blocking zones
may appear to be at wrong angles.
0807C-0
ADM ERROR
System
configuration
Invalid ACU / antenna combination.
Error code
(ID)
Unit
Severity
Description
Explanation
Table G-2: ACU event messages (Continued)
SAILOR900HP.book Page 10 Monday, July 18, 2016 12:44 PM
