STM SatLink 2900 VSAT modem
98-150471-A02
Appendix C: VMU settings
C-23
VMU se
ttin
gs
Modem configuration requirements
Type the following command in a modem console to set up the STM Satlink 2900 modem
to use the SAILOR 900 VSAT High Power:
Command
Description
odu antctrl waitstablize 300
This configures the antenna stability tries
which is the amount of times the modem
should try to logon before it tries the next
beam in its transponder list.
odu antctrl periodictime 5
This configures the polling frequency in
seconds between the modem and ACU.
odu antctrl port 0 (zero)
This configures the IP communication port
to default (5990). Use the command
odu
antenna
to configure the modem with
either SAILOR 800 VSAT or SAILOR 900
VSAT
odu antenna 30
This configures the antenna type to a
Thrane & Thrane / Cobham SATCOM
antenna.
NOTE:
odu antenna 52
is supported
from modem software 16.0.0 or higher. Use
the command
odu txtype
to set the
BUC for either SAILOR 800 VSAT or SAILOR
900 VSAT.
odu txtype 62
This configures the BUC type to a SAILOR
VSAT BUC
NOTE:
odu txtype 63
is supported
from modem software 16.0.0 or higher. Use
the command
odu lnb
to set the LNB for
either SAILOR 800 VSAT or SAILOR 900
VSAT.
odu lnb 62
This configures the LNB type to SAILOR
VSAT LNB
NOTE:
lnb 63
is supported from modem
software 16.0.0. or higher.
odu antctrl enable all
This will enable the communication
between the modem and ACU including
GPS input.
dvb rx autostart on
This will enable modem rx.
dvb tx autostart on
This will enable modem tx.
Save the new ODU Configuration:
Table C-8: Configuration of the STM SatLink 2900 VSAT modem
SAILOR900HP.book Page 23 Monday, July 18, 2016 12:44 PM
