POWERDRIVE CHARGER (EXTERNAL)
Charger Repairs
Page 3-30
2008-2011 Domestic Battery Charger Maintenance and Service Manual
3
AMMETER
See General Warning, Section 1, Page 1-1. See additional WARNING on page 3-1.
Ammeter Removal
1. Disconnect AC cord from the wall outlet and DC plug from the vehicle receptacle.
2. Remove the charger cover.
3. Disconnect the black wire from the DC cord (5), and the buss bar (3) from the ammeter
(Figure 3-26,
Page 3-30)
.
4. Remove the two nuts (2) that secure the ammeter to the charger face.
5. Remove the ammeter from the face of the charger.
Ammeter Installation
1. Place the ammeter in position in the charger face
(Figure 3-26, Page 3-30)
.
2. Install nuts (2) and tighten until ammeter is firmly secured.
3. Connect the black wire of the DC cord (5) to the left (as viewed from inside the charger) post of the amme-
ter.
4. Connect the buss bar (3) from the fuse link to the right post of the ammeter. Place flat washers on both
sides of the buss bar.
5. Thread nuts (4) onto both posts of ammeter until just past finger tight. While holding the inside nut, tighten
the outside nut (4) 1/4 turn.
See following CAUTION.
CAUT ION
• Do not allow ammeter post to rotate as the nut is tightened. Rotation of the post could result
in a damaged ammeter.
6. Install the charger cover.
7. Plug the charger into the vehicle and check ammeter for proper operation.
Figure 3-26 Ammeter
3
4
1
2
5
Summary of Contents for 2008-2011
