POWERDRIVE 3 – MODEL 26560
Charger Repairs
2008-2011 Domestic Battery Charger Maintenance and Service Manual
Page 6-33
6
AC Cord Installation
1. Insert the black, white, and green leads of the new AC cord into the charger through the hole in the
charger face.
2. Connect the AC cord black wire (1) to the AC circuit breaker (3)
(Figure 6-22, Page 6-24)
.
3. Place a piece of heatshrink tubing (7) over the AC cord white wire (4).
4. Connect the AC cord white wire (4) to the tan primary coil wire
(Figure 6-22, Page 6-24)
.
5. Slide the heatshrink tubing (7) over the connection and apply heat to the heatshrink to insulate the con-
nection between the AC cord white wire (4) and the tan primary coil wire.
See following WARNING.
ý
WARNING
• Make sure the electrical connections are properly insulated. Failure to properly insulate
electrical connections in the charger could result in a short circuit.
6. Connect the green wire (2) to the charger base. Tighten the screw and nut on the green (ground) wire
terminal to 18 in-lb (2.0 N·m).
7. Position the strain relief bushing on the AC cord.
8. Using pliers, install the strain relief bushing and AC cord into the mounting hole in the charger face.
9. Install the charger cover.
Summary of Contents for 2008-2011
