![background image](http://html1.mh-extra.com/html/club-car/2008-2011/2008-2011_maintenance-and-service-manual_2626718248.webp)
IQ PLUS CHARGER (ONBOARD)
Test Procedures
Page 9-14
2008-2011 Domestic Battery Charger Maintenance and Service Manual
9
Test Procedure 4B – Both Diodes Failed
See General Warning, Section 1, Page 1-1.
To check the diodes, use Test Procedure 4A – Single Diode Failure on page 9-13. If both diodes have failed
closed, both charger fuse links will be blown. If both diodes have failed open, the relay will close and the trans-
former will hum, but the ammeter will not indicate any output and the AC circuit breaker may trip off. If both
diodes have failed open or closed, the entire heatsink must be replaced. To determine why both diodes failed:
1. Check the batteries and the receptacle to ensure that they are wired in the correct polarity.
(Figure 9-2,
Page 9-3)
.
2. Make sure the charger is wired correctly: The DC cord red wire should be connected to the center ter-
minal of the heatsink, the DC cord blue wire should be connected to the control board, and the DC cord
black wire should be connected to the left side of the ammeter (when viewed from inside the charger)
(Figure 9-3, Page 9-6)
. If a reverse polarity connection is made between the charger and the batteries,
both fuse links will blow when the DC cord is connected to the vehicle, whether or not the AC cord is
plugged into an outlet.
3. Make sure the charger is wired to the vehicle correctly; the vehicle’s DC cord red wire should be con-
nected to the same large solenoid post as the 6-gauge red wire connected to the positive (+) post of bat-
tery no. 1. The DC cord blue wire should be connected to the sense lead fuse. The DC cord black wire
should be connected to the terminal block located on the vehicle component mounting plate
(Figure 9-2,
Page 9-3)
. If a reverse polarity connection is made between the charger and the batteries, both fuse links
will blow when the DC cord is connected to the vehicle, whether or not the AC cord is plugged into an
outlet.
4. On rare occasions, both diodes may fail as a result of a lightning strike at the charging location.
5. Excessive heat due to a loose connection may also cause both fuse links to blow. Be sure fuse connec-
tions are tightened to 22 in-lb (2.5 N·m).
6. Ensure that the charger and vehicle are wired properly and all connections are clean and tight.
TEST PROCEDURE 5 – CHARGER DC CIRCUIT CONTINUITY TEST
See General Warning, Section 1, Page 1-1.
1. Disconnect the AC cord from the wall outlet.
2. Disconnect the batteries and discharge the controller.
See Disconnecting The Batteries on page 1-3.
Figure 9-9 Diode Test
Figure 9-10 Diode Test – Probes Reversed
DISCONNECTED
SECONDARY
COIL WIRE
Summary of Contents for 2008-2011
