POWERDRIVE 2 CHARGER (EXTERNAL)
Charger Repairs
2008-2011 Domestic Battery Charger Maintenance and Service Manual
Page 5-27
5
Ammeter Installation
1. Place the ammeter in position in the charger face and ensure that the locking tabs are secure
(Figure 5-20, Page 5-27)
.
2. Connect the DC cord red wire (1) and the white wire (3) to the ammeter terminals.
3. Install the charger cover.
4. Plug the charger into the vehicle and check ammeter for proper operation.
FUSE LINK
See General Warning, Section 1, Page 1-1. See additional WARNING on page 5-1.
Fuse Link Removal
1. Disconnect AC cord from the wall outlet and DC plug from the vehicle receptacle.
2. Remove the charger cover.
3. Gently press the fuse toward the transformer to remove the fuse from the mounting tab.
4. Remove the two nuts securing the two black wires to the fuse terminals and remove the fuse.
Fuse Link Installation
1. Connect the short black wire from the rectifier to one of the fuse terminal posts and install the nut. Tighten
nut to 23 in-lb (2.6 N·m).
2. Connect the DC cord black wire to the other fuse terminal post and install the nut. Tighten nut to 23 in-
lb (2.6 N·m).
3. Gently press the fuse assembly into the mounting tab so that the fuse link is visible from the side of the
charger.
4. Install the charger cover.
Figure 5-20 Ammeter
3
4
1
Summary of Contents for 2008-2011
