Cleveland SteamCraft V, Service Manual

Page: 20 / 96

Printed 4/90
Page 16
CET-16 Service Manual
3. Thread the nipple into the bulkhead coupling of the untreated water
connection.
4. Using a pipe wrench, thread the assembled strainer and nipple into the
coupling until it is tight, and the strainer access nut is facing down.
For efficient operation, the steamer should be level both front to back and
side to side. The adjustable legs of the SteamCraft V are four inches long
when the adjustable feet arc fully retracted. The adjustable feet can be
extended approximately two inches, providing adjustment for leveling the
steamer.
1. Refer to the Installation Check List, Table 2-1 Check that all Preparation
Tasks are complete, Check that all Unpacking and Assembly tasks are
complete.
2. Looking at the counter where the SteamCraft V will be placed, estimate
the location of the four corners that will support the legs. Using a
carpenter's level, determine the highest comer and mark it with an "H".
WARNING
INJURY AND EQUIPMENT DAMAGE could result
from improper lifting
. The SteamCraft V weighs
approximately 120 pounds. Use an adequate number
of personnel with experience in lifting heavy
equipment to place the Steam-Craft V on the counter.
3. Lift the SteamCraft V into place on the counter. Do
not change the height of the leg in the highest corner
of the counter as marked in step 2. Using a
carpenter's level, adjust the other three legs until the
unit is level both front to back and side to side.
Position and Level Steamcraft V