Cleveland SteamCraft V, Service Manual

Page: 21 / 96

CET-16 Service Manual Page 17
Connect Electrical Line
Printed 4/90
Figure 2-15. Rear Panel Removal
Referring to Electric Power Line (page 9), verify that the electric power
lines have been extended to the SteamCraft V properly. Connect them to
the terminal block inside the rear cover as described below.
1. Move the SteamCraft V so the rear panel can be easily reached.
2. Remove the rear panel by removing six screws (figure 2-15) that hold it
in place. Save the screws.
3. Mechanically secure the flexible conduit to the electrical conduit
access note (figure 2-15). (See Canadian Wiring Considerations
below.)
4. The terminal block and ground connection are near the left side of the
rear opening. The unit has either a three terminal block for 3 wire
DELTA connection, or a four terminal block for 4 wire WYE
connection.
5. Refer to the connection diagrams in figure 2-16, and connect the wires
to the terminal block and ground connector accordingly.
6. Each steamer MUST be electrically grounded by the installer
.
7. All SteamCraft V's are wired for 3 phase only, and are not convertible
to single phase.
8. If no further work is required inside the SteamCraft V, secure the rear
panel i
n
place using six mounting screws (figure 2-15).