CET-16 Service Manual Page 9
Electric Power Line
Furnishing and installing the electrical power Iines, switches, fuse boxes,
connectors and their accessories is the responsibility of the owner and/or
installer. Figure
2-6
illustrates an electrical layout recommended by
Cleveland Range. When installing the electrical power lines and acces-
sories, observe the following instructions.
1. In the United States, install the electrical power lines in accordance
with
local codes and/or the National Electri
c
Code, ANSI/NFPA No.
70-1990 (USA).
2.
In Canada, install the electrical power lines in accordance with local
codes and/or the Canadian Electrical Code, CSA Standard C22.1
(Canada).
3. Install the proper size disconnect switch, circuit breaker or fuses, and
wire and conduit to conform to all local codes and the national codes
cite
d
above. See table 2-3 for wire requirements.
Table 2-3. Minimum Wire Requirements
LIN
E
KILO
LIN
E
WIRE
VOLTAGE
WATTS
AMPS*
GAUGE**
208
16.7
46
6
220
153
40
6
240
18.0
43
6
380/220
153
23
10
415/240
18.0
25
10
440
153
20
10
480
18.0
22
10
*All 3 Phase
**Use copper wire rated for 75° C.
Printed 4/90
Summary of Contents for SteamCraft V
