Cleveland SteamCraft V, Service Manual

Page: 58 / 96

Page 56 CET-16 Service Manual
cont. (208,230, or 460 VAC). The primary circuit components are: the
transformer primary coil, the fan motor, and the steam generator and fan
heater elements. Cleveland Range supplies these components in groups
compatible with most international power systems. To identify the
electrical characteristics of the primary circuit components, refer to the
Product Identification plate on the left side of the unit (Figure 6-1), and the
Performance Data plate on the fan motor (Fan Assembly, Figure 6-1).
When servicing, repairing, or replacing any of the primary circuit, com-
ponents, observe the requirements of the Product Identification and the
Performance Data plates, and pay particular attention to the following.
1. For operation at 208-240 VAC, the primary windings of the stepdown
transformer most be wired in paraIlel.
2. For operation at 440-480 VAC the primary windings of the stepdown
transformer must be wired in series.
3. Steam generator and fan heater elements are available for 208,230, or
460 VAC operation. When testing or replacing steam generator or fan
heater elements, refer to Heater Elements and Tables 5-1 and 5-2.
4. Normally, the SteamCraft V control panel is factory set for 60 Hz
operation. For 50 Hz operation, Cleveland Range supplies the control
panel with jumper wire JP1 removed. See Figure 5-2. If installation
requires removal of JP1 in the field, the conformal coating must be
repaired with Cleveland Range approved coating material.
Table 5-1. Steam Generator Heater Elements
PART NO. WATTS VOLTS OHMS +5%
101223 2660 205 16
1012231 2660 230 48
1012232 2660 460 78
101224 5300 205 8
1012241 5300 240 10
1012242 5300 480 39
Table 5-2. Fan Heating Elements
PART NO. WATTS VOLTS OHMS +5%
101227 300 208 139
1012271 300 230 172
1012272 300 460 666
Printed 4/90