Cleveland SteamCraft V, Service Manual

Page: 19 / 96

CET-16 Service Manual Page 15
Install The Slide Racks
1. Refer to figure 2-12 . Each rack has four loops: two on top
and two on the bottom. Hold one slide rack so the ends of the
hanger loops are pointing down.
2 . Slide one rack into the steamer compartment with the hanger
loops toward one side of the compartment
3. Hoop the two top loops over the top pins, then hook the
bottom loops over the two bottom pins.
4. Repeat steps 1 through 3 for the other rack.
Install The Water Strainer
As illustrated in figure 2-l3, the water strainer is supplied with a 1/4"
brass nipple threaded into the strainer outlet This nipple fits the untreated
water connection (cold water inlet, figure 2-14).
1. Check that the nipple is connected to the strainer output as indicated
by the flow direction arrow on the strainer body. 2. Apply pipe
dope or teflon tape to the brass nipple.
Printed 4/90
Figure 2-12 . Slide Racks