5-4
CP2210 Service Manual
020-100556-04 Rev. 1 (01-2012)
Section 5: Parts and Module Replacement
5.3
Safety Warnings and Guidelines
Always power down and disengage all power sources from the projector
before servicing.
• Once the projector is powered down, allow the cooling fans to automatically turn OFF
before disconnecting from AC and opening the projector. This takes approximately 15
minutes.
• All module replacement procedures must be performed by Christie authorized service
technicians.
Observe all electrostatic precautions. Use a grounded wrist strap when
handling electronic assemblies. Gloves are required when handling critical optical
components.
5.4
Replacement Procedures
5.4.1 Servicing Guidelines
• Follow all service safety warning and guidelines.
• Refer to
Section 5.2 Index of Parts and Modules
along with
Appendix C: Exploded Views
to locate each
module within the projector.
• When re-installing a module, follow “removal” instructions in reverse unless otherwise indicated.
• Refer to
Section 6 Interconnections
when re-connecting harnesses.
5.4.2 Tools Required
• Low and high security keys
• Phillips
™
screwdrivers - #1, #2 and #3 long stems
• Hex Keys/Drivers - 2.5mm, 3mm, 4mm and 5mm
• Wrench - 17mm and 19mm
• Electrostatic protective strap and pad
• Disposable Nitrile gloves
(included with optical components)
