CP2210 Service Manual
1-1
020-100556-04 Rev. 1 (01-2012)
1 Introduction
To prevent physical injury or equipment damage, it is important to
study Section 2 Service Guidelines in its entirety before performing any service
procedure.
This manual provides technical information for assisting Christie authorized service technicians in the
servicing and repair of CP2210 projector models.
Disclaimer:
Every effort has been made to ensure the information in this document is accurate and reliable. However, due to
constant research, the information in this document is subject to change without notice. Christie Digital Systems assumes no
responsibility for omissions or inaccuracies. Updates to this document are published regularly, as required. Please contact
Christie Digital Systems for availability.
1.1
Labels and Marking
Observe and follow any warnings and instructions marked on the projector.
Danger symbols indicate a hazardous situation which, if not avoided,
will result in death or serious injury. This signal word is to be limited to the most
extreme situations.
Warning symbols indicate a hazardous situation which, if not avoided,
could result in death or serious injury.
Caution symbols indicate a hazardous situation which, if not avoided,
could result in minor or moderate injury.
NOTICE:
Addresses practices not related to personal injury.
1.2
Projector Skins
UV HAZARD! When servicing the projector with the top lid removed anyone
within the immediate vicinity must wear safety glasses with side shields and Christie
approved protective safety clothing (P/N: 598900-095).
Never operate the projector or the fans without all the covers installed.
Durable covers are used to protect the components within the projector. Several removable covers
(also called skins) allow access to serviceable components without having to completely disassemble
the projector. For details, refer to
Appendix C: Exploded Views
.
Rear Access Door
Located at the back of the projector is the rear access door, which includes a low security access lock/
key and the Touch Pad Controller (TPC). Mounted to the inside of the door is the lamp blower assem-
bly and the lamp changeover tool required to tighten/loosen the cathode clamp.
