Section 5: Parts and Module Replacement
CP2210 Service Manual
5-17
020-100556-04 Rev. 1 (01-2012)
5.5.19 Standby Power Supply
UV HAZARD!
Always wear protective safety clothing and a face shield when performing
service with the safety shield removed and a lamp installed.
The standby power supply (
Figure 5-23
) is secured to the projector housing within the lamp compartment next
to the lamp blower.
(Estimated Replacement Time: 15 minutes)
1. Remove the top lid. Refer to
5.5.5 Top Lid, on page
5-7
.
2. Remove the safety shield. Refer to
5.5.12 Safety
Shield, on page 5-10
.
3. Open the lamp door. Refer to
5.5.10 Lamp Door, on
page 5-9
.
4. Remove the lamp (if installed). Refer to
5.5.15
Lamp Replacement, on page 5-13
.
5. Remove the top bracket by loosening the captive
screw, shown in
Figure 5-22
.
6. Remove the AC power cord from the bottom of the
power supply. (
Figure 5-23
)
Figure 5-22 Power Supply Bracket
Figure 5-23 Standby Power Supply
