5-24
CP2210 Service Manual
020-100556-04 Rev. 1 (01-2012)
Section 5: Parts and Module Replacement
5.5.24 Reflector Assembly (Including Heat Dump)
UV HAZARD!
Always wear protective safety clothing and a face shield when performing
service with the safety shield removed and a lamp installed.
(Estimated Replacement Time: 60 m 10 minute LampLOC
™
Alignment)
1. Remove the top lid. Refer to
5.5.5 Top Lid, on page 5-7
.
2. Remove the safety shield. Refer to
5.5.12 Safety Shield, on page 5-10
.
3. Remove the lamp (if installed). Refer to
5.5.15 Lamp Replacement, on page 5-13
.
4. Using a 5mm hex key, remove the four screws securing the reflector. Three of these screws are located on
the bracket outside the reflector. The fourth screw is located inside the casing below the reflector (
Figure
5-33
).
5. Carefully lift the reflector assembly straight up and out of the unit, being careful not to touch the UV filter
glass.
Figure 5-33 Remove Reflector
6. Remove the two M3 screws securing the lamp temperature sensor to the lamp cover (
Figure 5-34
).
7. Remove the two M3 screws securing the
sensor to the cover (
Figure 5-34
).
8. Use a #2 Phillips
™
to remove the 13 screws
securing the front lamp cover.
9. Reverse the above steps to reinstall. Perform
LampLOC
™
alignment. For details, refer to
the
CP2210 User Manual (P/N: 020-
100410-xx)
.
Figure 5-34 Front Lamp Cover & Lamp Shield
