5-50
CP2210 Service Manual
020-100556-04 Rev. 1 (01-2012)
Section 5: Parts and Module Replacement
7. Reverse the above steps to install the cold mirror.
NOTE:
When installing, ensure that the reflective
surface faces inwards
(
Figure 5-73
)
.
8. LampLOC™ and MCGD must be calibrated after installation. For details, refer to the
CP2210 User
Manual (P/N: 020-100410-xx)
.
Figure 5-73 Installing Cold Mirror
5.6.14 Fold Mirror 1
NOTICE:
Wear gloves when handling the fold mirror.
(Estimated Replacement Time: 20 minutes; includes 10 minute calibration)
Fold Mirror 1 is accessed from the front left-corner of the projector. The alignment screws are positioned along
the top of the light tube, which allows them to be easily adjusted.
1. Remove the top lid. Refer to
5.5.5 Top Lid, on page 5-7
.
2. Remove the side skin service door. Refer to
5.5.11 Exhaust Panel Skin, on page 5-10
.
3. Remove the contrast aperture. Refer to
5.6.11 Contrast Aperture, on page 5-48
.
4. Remove the light sensor module. Refer to
5.6.12 Light Sensor Module, on page 5-48
.
5. Loosen the 2.5mm locking hex screw and remove the two 2.5mm hex screws securing fold mirror 1 to the
bracket (
Figure 5-74
).
6. Remove fold mirror 1.
7. Reverse the above steps to install fold mirror.
NOTE:
When installing, ensure that the reflective surface
faces inwards (Figure 5-75).
Figure 5-74 Fold Mirror
A
2.5mm Locking Hex Screw
B
Hex Screw (1 of 2)
