5-30
CP2210 Service Manual
020-100556-04 Rev. 1 (01-2012)
Section 5: Parts and Module Replacement
5.5.28 Light Dump
The light dump is mounted to the front of the light engine compartment and is held in place by a single captive
screw.
(Estimated Replacement Time: 20 minutes)
1. Remove the top lid. Refer to
5.5.5 Top Lid, on page 5-7
.
2. Remove the high security lid. Refer to
5.5.6 High Security Lid, on page 5-7
.
3. Using a 3mm hex key, remove the two screws securing the light engine cover (
Figure 5-42
).
Figure 5-42 Remove Light Engine Cover
4. Using a #1 Phillips
™
, loosen the captive screw securing the light dump (
Figure 5-43
).
5. Reverse the above steps to install. Ensure that the light dump is aligned with the alignment pin when
installing.
Figure 5-43 Remove Light Dump
