Chevrolet 2011 Corvette, Owner'S Manual, Page: 142 / 436

Black plate (20,1)
Chevrolet Corvette Owner Manual - 2011
5-20 Instruments and Controls
. Make sure to fuel the vehicle
with quality fuel. Poor fuel quality
causes the engine not to run as
efficiently as designed and may
cause: stalling after start-up,
stalling when the vehicle is
changed into gear, misfiring,
hesitation on acceleration,
or stumbling on acceleration.
These conditions might go away
once the engine is warmed up.
If one or more of these
conditions occurs, change the
fuel brand used. It will require at
least one full tank of the proper
fuel to turn the light off.
See Recommended Fuel on
page 9 ‑ 49 .
If none of the above have made
the light turn off, your dealer can
check the vehicle. The dealer
has the proper test equipment
and diagnostic tools to fix any
mechanical or electrical problems
that might have developed.
Emissions Inspection and
Maintenance Programs
Some state and local governments
may have programs to inspect
the on-vehicle emission control
equipment For the inspection, the
emission system test equipment is
connected to the vehicle
’ s Data Link
Connector (DLC).
The DLC is under the instrument
panel to the left of the steering
wheel. See your dealer if assistance
is needed.
The vehicle may not pass
inspection if:
. the check engine light is on with
the engine running, or if the light
does not come on when the
ignition is in ON/RUN while the
engine is off.
. the critical emission control
systems have not been
completely diagnosed by the
system. This can happen if
the battery has recently been
replaced or if the battery has run
down. The diagnostic system
evaluates critical emission
control systems during normal
driving. This can take
several days of routine driving.
If this has been done and the
vehicle still does not pass the
inspection , your dealer can
prepare the vehicle for
inspection.