Carrier Access Access Navigator, User Manual

Page: 628 / 704

18-172 August 2003 Access Navigator - Release 1.8
CLI Language Reference
CLI Command List
Status Remote
Purpose:
Displays a message listing the remote terminals at the far end of the DS1s. The
command syntax lets the operator request a specific DS1, range of DS1s, or all DS1s.
The Access Navigator can identify Carrier Access remote terminals, such as the Access
Bank II and Adit 600, over the DS1 FDL channel.
Security:
Level 3 (monitor)
Syntax:
status remote < n | all >
Example:
status remote all
Example:
status remote 1
Example:
status remote 1-7
Status The following states may appear:
Not Assigned
Not Assigned to ISDN
Not Available
In Service
User set Out of Service
Switch set Out of Service
Under user test control
In Loopback
Card not Installed
Facility failure
DS0 is not a drop side GR303 channel
DS1 Out of Service
Call Status The following states may occur when CRV is In Service:
Active – Call in progress (off hook)
Idle – Line available (on hook)
Permanent – Line not available because of permanent off-hook
state
n.a. – not applicable
Field Description
n DS1 number, 1 to 32, or a range of numbers such as 2-8.
all Display all DS1 remote interfaces.
Item Description