CareFusion Alaris 8110 series, Service Manual

Page: 74 / 172

Follow these procedures in order for the
most efficient disassembly of PCA Module
subassemblies. To reassemble the PCA
Module, reverse the disassembly steps.
NOTE:
Perform all maintenance on an
antistatic surface, preferably a grounded
antistatic mat.
Before adhering gaskets and labels to the
instrument, clean the surface with a cotton
swab or soft cloth lightly dampened with
70%
Isopropyl Alcohol.
5B-2
CORRECTIVE MAINTENANCE
PCA Module
Alaris
®
Syringe Module (8110 Series)
Alaris
®
PCA Module (8120 Series)
Technical Service Manual
5.2 DISASSEMBLY/REASSEMBLY
Disconnect the PCA Module from the Alaris
®
System before attempting disassembly.
CAUTION
To avoid the risk of electrical hazard or
damage to the instrument circuitry, do not
spray fluids directly onto the instrument or
allow fluids to enter the instrument.
CAUTION
Table 5B-1. Required Materials, Supplies and Tools - PCA Module
NOTE:
Contact/source information is subject to change.
• Silicone grease, Dow Corning Molykote
33
, or equivalent (
http://www.dowcorning.com
)
•
#1
Phillips screwdriver
•
#2
Phillips screwdriver
• Small diagonal cutters
• Lint-free cloth (such as, Kimwipes or lint-free tissue)
The following items are available from
TECHNI-TOOL
(
800.832.4866
; http://www.techni
–
tool.com
).
• Hex Head Bit,
1
/
16
HX
,
1
15
/
16
” Length,
TT #758SC0172
(used for
0.062
” Park Position Collar Setscrew)
• Power bit, ball hex
5
/
64
,
¼ HX
,
3½
” length,
TT #758SC0172
• Power bit, ball hex
3
/
32
,
¼ HX
,
3½
” length,
TT #758SC0173
• Tamper-resistant Torx bit, size T8,
1
15
/
16
“ length,
TT #758SC0321
• Torque screwdriver with a minimum range of
3
-
15
in-lbs. Recommend torque screwdriver,
Micro-Adjustable,
TT #844SC5002
or
TT #304TO034
.
• Torque wrench with a minimum range of
40
in-lbs. Recommend
¼
torque wrench
#155IE150
.
• Torx Bit, Size
T6
,
1
15
/
16
” Length,
TT #758SC0301
The following items may be purchased from McMaster-Carr (
562.692.5911
; http://www.mcmaster.com
).
• Insert-bit holder,
¼
” hex drive,
6
” length,
#7225A42
• ¼” drive
9
/
16
” deep-well socket (available at any hardware or tool store)
• Slotted screwdriver,
1
/
8
” tip width,
3
” length blade,
#5682A37
• Insert-Bit,
0.05
” Hex Size,
¼
” Hex Shank,
1
” Length,
#8526A46
(used for
0.05
” Park Position Collar
Setscrew)