CareFusion Alaris 8110 series, Service Manual

Page: 110 / 172

TROUBLESHOOTING
6-4
Alaris
®
Syringe Module (8110 Series)
Alaris
®
PCA Module (8120 Series)
Technical Service Manual
Pressure Disc Installed
(Syringe Module only)
1. Pressure sensing disc installed
during an infusion.
2. Sensor not sensing disc.
1a. Press
RESTART
key.
1b. Check for proper pressure sensing
disc installation. Disc must snap into
holder.
2. If pressure sensing disc is not
installed, check binary sensor by
inserting and removing disc.
Use Maintenance Software to
perform Binary Switches Test.
Replace Pressure Sensor Board,
Pressure Sensor Harness, or Flag
Disk Holder if necessary.
3. Return to factory.
Table 6-1. Technical Troubleshooting Guide
(Continued)
Message Probable Cause Remedy
Pressure Disc Removed
(Syringe Module only)
1. Pressure sensing disc removed
during an infusion.
2. Sensor is sensing disc.
1a. Reinsert pressure sensing disc and
press
RESTART
key.
1b. Check for proper pressure sensing
disc installation. Disc must snap into
holder.
2. If pressure sensing disc is installed,
check binary sensor by inserting and
removing disc.
Use Maintenance Software to
perform Binary Switches Test.
Replace Pressure Sensor Board,
Pressure Sensor Harness, or Flag
Disk Holder if necessary.
3. Return to factory.
Syringe Calibration 1. System detected Force Sensor
Board, pressure disc, or Barrel
Clamp requires calibration.
2. Force Sensor Board, pressure disc,
Syringe Size Sensor Assembly, or
Logic Board fails calibration.
1. Use Maintenance Software to
perform applicable calibration(s) or a
full calibration.
2. Replace part(s) failing calibration.
€
Perform applicable calibration and
verification.
3. Return to factory.