Cardinal Health IVAC 571, Technical & Service Manual

Page: 14 / 104

IVAC® Volumetric Pump (Models 571 & 572) 14/104 1000SM00018 Issue 2
Configuration & Calibration
Self-test mode is used to access a number of configuration and test routines which are designed to test and verify many
of the pump functions, defaults and calibrations without requiring internal inspection. Configuration settings are also
accessed via self-test mode.
Each test is accessed by selecting a Test ID number as shown in the table below.
Self-Test Mode
Test ID Description
001 Software Revision Display
002 Configuration Status Display
003 Flash Display Test
004 Segment Display Test
005 Sequence Display Test
006 EEPROM Test and Data Display
007 A/D Channels Test
008 Rate Calibration Display/Set
009 * Configuration Rate Display/Set
010 Maximum Rate Display/Set
011 * VTBI Configuration Display/Set
012 Pressure Display
013 Pressure Calibration Set
014 Maximum Occlusion Pressure Limit Display/Set
015 Default Occlusion Pressure Limit Display.Set
016 Alarm History Display/Clear
017 Switch Test
018 AC Power Run Time Display/Reset
019 Battery Run Time Display/Reset
020 Secondary Mode Completion Tone Display/Set
021 Air-In-Line Test
022 I/O Port Test
023 Language Display/Set
024 CIM ID Display/Set
025 Alarm Tone Display/Set
026* AIL Alarm Threshold Display/Set
027 System Vacuum Display
028 Enter Operational Setup Mode
029 Burn-In Test
030 Not used
031* Infusion Mode Configuration Display/Set
* A mode select jumper (part number 132350) must be
used to change settings, see 'Mode Select Jumper' for
further details.
Exiting Self-Test Mode
Self-test mode can be exited at any time:

Turn the pump off by pressing the
ON/OFF
switch
OR

Select test
028
then press the
RUN/HOLD
switch
to enter the start-up mode of operation
Entering Self-Test Mode
1. Press the
RUN/HOLD
and
ON/OFF
switches
simultaneously until the display turns on. Initially,
the current software revision level is displayed.
2. Press the RUN/HOLD switch. The Information
Display will read: TEST ID and the Numeric
Display will read: 002 which means the pump is
ready to start test 002 .
Note: The display may bypass the display of the
software revision level and advance directly to
TEST ID 002
, depending on how long the
RUN/
HOLD
switch is held down.
3. Use the
J K
switches to select the Test ID
required.
Test Execution
1. After selecting the Test ID number (see above),
press the
RUN/HOLD
switch to start the test.
2. To exit a test, press the
RUN/HOLD
switch.
The three columns of
J K
switches
allow faster/slower increments:
Left = 100's
Centre = 10's
Right = Units