Canon PowerShot G3, Service Manual

Page: 89 / 185

3-17
CHAPTER 3. REPAIR INSTRUCTION
2.2.14 Assembling the FINDER UNIT
(1) FINDER UNIT
1. Set the OPTICAL UNIT in the retracted position.
2. Rotated the gear in the direction of mark
A
as far as it can go. When it reaches its end, return it slightly so
that cutouts are aligned with the two holes of the gear.
3. Insert the LED HOLDER to the FINDER UNIT.
4. Install the claw.
5. Install the dowel in the opposite side.
6. Install the two screws of
q
.
NOTE (Assembling)
If the OPTICAL UNIT is not set in the retracted position, remove the CCD HOLDER UNIT
(refer to page 3-27) and rotate the portion B of the OPTICAL UNIT in the direction of mark
C
with hands
until the OPTICAL UNIT is set in the retracted position.
Fig. 3-17 Assembling the FINDER UNIT
(1)-6
(1)-5
(1)-2
(1)-4
Claw
FINDER UNIT
Cutout
Hole
Dowel
Dowel
q
Rotate the gear in the direction of
mark
A
as far as it can go. When
it reaches its end, return it slightly
so that cutouts are aligned with the
two holes of the gear.
A
NOTE (Assembling)
(1)-1
(1)-1
LED HOLDER
OPTICAL UNIT/
LED HOLDER
(1)-3
XA4-9170-359
BLACK
M1.7
(SELF TAP)
3.5mm
q
C
B