Canon IPF670, User Manual

Page: 539 / 652

2
On the Tab Selection screen of the Control Panel, press
◀
or
▶
to se-
lect the Settings/Adj. tab ( ).
Note
•
If the Tab Selection screen is not displayed, press the Menu button.
3
Press the OK button.
The Set./Adj. Menu is displayed.
4
Press ▲ or ▼ to select Adjust Printer , and then press the OK button.
5
Press ▲ or ▼ to select Feed Priority , and then press the OK button.
6
Press ▲ or ▼ to select Adjust Length , and then press the OK button.
7
Press ▲ or ▼ to select AdjustmentPrint or Change Settings , and
then press the OK button.
When you select AdjustmentPrint , a test pattern is printed for you to
measure the scale and calculate the discrepancy. The scale bar prints
Millimeter in 50 mm increments and Inch in 1-inch increments.
Note
•
A test pattern is printed in black when you choose A:High or in magenta if you choose B:Standard/Draft .
•
To cancel printing the test pattern for adjustment, hold down the Stop button. When " Stop printing? " is dis-
played, press ▲ or ▼ to select Yes , and then press the OK button.
8
Press ▲ or ▼ to enter the amount of discrepancy, and then press the OK button.
If the scale is shorter than the actual size, use a positive setting value. If it is longer, use a negative value.
The feed amount can be adjusted in 0.02% increments.
Adjusting the Vacuum Strength
Adjusting the Vacuum Strength
When printing on heavyweight paper or paper that curls or wrinkles easily, if the Printhead rubs against paper, adjust-
ing the level of suction against paper on the Platen may improve results.
Important
•
Paper rubbing against or becoming caught on the Printhead may jam or result in printed documents that are soiled.
1
On the Tab Selection screen of the Control Panel, press
◀
or
▶
to se-
lect the Paper tab ( ).
Millimeter Inch
iPF670 Adjusting the Vacuum Strength
User's Guide
Adjustments for Better Print Quality
Adjusting the feed amount
539