Canon imageRUNNER ADVANCE 525 I, Service Manual

Page: 502 / 651

COPIER (Service mode for printer) > OPTION (Specification setting mode) > USER
PTJAM-RC 2 Auto reprint setting at PDL print jam
Detail To set to automatically restart printing after jam recovery that occurs with PDL print.
Use Case Upon user's request
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 0 to 1
0: Not automatically reprinted, 1: Automatically reprinted
Default Value 1
PDL-NCSW 2 Card mngm setting for PDL print job
Detail *Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set to make PDL print job to be subject to card management by the Card Reader.
With the setting to enable this mode, PDL print is available only when the card ID of the card
inserted to the Card Reader matches the department ID.
Use Case
Upon user's request
Adj/Set/Operate Method
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range
0 to 1
0: PDL print is available with no card inserted.
1: PDL print is available only when the card ID matches the department ID in the case that the
card is inserted.
Default Value
0
PS-MODE 2 Setting of PS print line drawing
Detail To set the image processing at PS print.
Set 8 when line width differs depending on the drawing position although the same line width is
set.
Use Case Use case When right and left ruled lines are different in width
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 0 to 65535
0 to 7: Spare
8: Strokeadjustment is enabled.
9 to 65535: Spare
Default Value 0
CNCT-RLZ 2 Setting of connection serialize function
Detail Connection serialize is a function to assure job grouping function of imageWARE Output Manager
Select Edition V1.0.
The setting to enable this mode can avoid job rearrangement because the machine does not
receive job data from other connection until it completes job data reception from the current
connection.
Use Case Upon user's request
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range
0 to 1
0: OFF, 1: ON
Default Value
0
Supplement/Memo
Connection: Connection to be established through network between multiple hosts (PC, etc).
Job grouping function: A function of imageWARE Output Manager Select Edition V1.0. This is to
prevent job interruption from other PC by group job (sending multiple jobs in 1 session at job
transmission).
8. Service Mode
492