Canon imageRUNNER ADVANCE 525 I, Service Manual

Page: 388 / 651

COPIER (Service mode for printer) > ADJUST (Adjustment mode) > ADJ-XY
STRD-POS 1 Adj frt side read pstn: DADF stream read
Detail To adjust the Scanner Unit (Front) position in feed direction at DADF stream reading.
As the value is changed by 1, the position moves by 0.1 mm.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
Use Case When clearing the Reader-related RAM data/replacing the SATA Flash PCB
Adj/Set/Operate Method 1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, write the changed value in the service label.
Display/Adj/Set Range -40 to 20
Unit mm
Default Value 0
Related Service Mode COPIER> FUNCTION> INSTALL> STRD-POS
Amount of Change per
Unit
0.1
ADJ-X-MG 1 Fine adj img ratio: book mode, vert scan
Detail To make a fine adjustment of image magnification ratio in vertical scanning direction at copyboard
reading.
As the value is changed by 1, the image magnification ratio is changed by 0.01%.
+: Reduce
-: Enlarge
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
Use Case When clearing the Reader-related RAM data/replacing the SATA Flash PCB
Adj/Set/Operate Method 1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, write the changed value in the service label.
Display/Adj/Set Range -200 to 200
Unit %
Default Value 0
Amount of Change per
Unit
0.01
ADJY-DF2 1 Adj read start pstn:DADF,back,horz scan
Detail To adjust the back side image reading start position in horizontal scanning direction at DADF
reading.
As the value is incremented by 1, the image position is moved to the rear side by 0.1 mm.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
Use Case When clearing the Reader-related RAM data/replacing the SATA Flash PCB
Adj/Set/Operate Method 1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, write the changed value in the service label.
Display/Adj/Set Range -15 to 15
Unit mm
Default Value 0
Amount of Change per
Unit
0.1
8. Service Mode
378