Canon imagePROGRAF iPF9400, User Manual

Page: 644 / 964

Warnings
Warnings
Take note of the following warnings when added custom paper other than Canon genuine paper and feed confirmed
paper to the printer driver and the printer itself.
About the Cutter
• Depending on the paper, there are types that cannot be cut by the cutter unit, and types that speed deterioration of
the blade and cause damage to the cutter. For thick paper, hard paper, etc. do not use the cutter unit, and instead
cut the roll paper using scissors, etc. after printing. In this case, select
User Cut as the Automatic Cutting Set-
tings in the Roll Paper Settings dialog box.
Note
•
If the cutter is damaged, contact your Canon dealer for assistance.
•
For details on the methods for cutting roll paper, see "Specifying the Cutting Method for Rolls."
→P.546
About the Printhead
•
If the printhead rubs against the paper during printing, this may cause damage to the printhead. If the printhead is
rubbing against the paper, configure the
Vacuum Strength in the Step 5: Configure the amount of ink used
dialog box as follows.
• For paper-based media such as Heavyweight Coated Paper: Set to Strong or Strongest
• For film-based media such as CAD Tracing Paper: Set to Standard , Strong , or Strongest
•
For thin paper of thickness 0.1mm or less: Set to Weakest
Note
•
If the printhead still rubs even after changing the Vacuum Strength , set the Head Height to be higher in the Step 5: Config-
ure the amount of ink used dialog box.
•
For details on how to handle the printhead rubbing against the paper,
see "Paper rubs against the printhead."
→P.889
About Borderless Printing
• When performing borderless printing on paper where the ink does not dry well, the cutter unit may leave scratches
where it touches the printed surface, or may not cut correctly. In this kind of situation, configure the amount of time
to wait for the ink to dry after printing using
Drying Time in the Roll Paper Settings dialog box.
Alternatively, if the paper cannot be cut well by the cutter, set the Automatic Cutting Settings to User Cut in the
Roll Paper Settings dialog box, and cut the roll paper using scissors, etc.
About the Print Quality
• If the edges of images are blurry, set the Vacuum Strength to be weaker in the Step 5: Configure the amount of
ink used dialog box.
• If lines are warped or scratched, set the Head Height to be lower in the Step 5: Configure the amount of ink
used dialog box.
• If the amount of ink used is too much, wrinkles may appear and the ink may bleed in the printed material. Further-
more, if the amount of ink used is too little, color production may be poor and lines may become scratched. In this
kind of situation, change the amount of ink used in the
Step 5: Configure the amount of ink used dialog box.
• If horizontal bands with different color tone appear in the printed material, execute Paper Feed Adjustment in the
Step 4: Paper feed adjustment dialog box. If you have already executed Paper Feed Adjustment , execute Adj.
Fine Feed from the printer control panel and fine tune the amount of paper feed.
Note
•
For details on Adj. Fine Feed ,
see "Fine-Tuning the Paper Feed Amount."
→P.809
•
If horizontal bands appear even after executing Adj. Fine Feed , refer to "Banding in different colors occurs" in "Trouble-
shooting". (See "Banding in different colors occurs.")
→P.891
Warnings (Mac OS X) iPF9400
User's Guide
Handling and Use of Paper
Media Configuration Tool (Mac OS X)
644