3. Routing the Scanner Cable
Note:
You need the following tools when routing the scanner cable:
1. Mirror positioning tool (FY9-3009-040)
2. Pulley click(FY9-3010-000
Work in the order indicated in Figure 4-305.
1) Put the steel ball into the pulley hole
q
, and wind the cable 3.5 times toward the inside and 6 times
toward the outside (both front and rear).
2) Fix the cable in place with the pulley click.
3) Set the mirror positioning tool
w
. (Se p. 4-11.)
4) Set the cable as shown
e
,
r
,
t
,
y
.
5) Loosen and then tighten the set screw
u
of the drive pulley so that the tension of the scanner cables
is even throughout.
6) Fix the No. 1 mirror mount and the scanner cable metal fixing in place
i
.
7) Fix the cable spring stay in place so that the spring length is 32 ±1 mm
o
.
Figure 4-305
32
±
1mm
2
3
6
4
8
5
9
1
2
7
Set the mirror positioning
tool.
Loosen the set screw so
that the pulley is free to
rotate.
Set screws
Put the steel ball into the pulley hole.
Wind it 3.5 times toward
the inside and 6times
toward the outside;
then, snap on
the pulley clip.
Pulley clip
Steel ball
COPYRIGHT © 1996 CANON INC. CANON GP215/200 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON)
4–10
4. MECHANICAL SYSTEM