Canon CXDI-40G COMPACT, Service Manual

Page: 188 / 189

Page 1 of 2
CXDI-40G COMPACT Inspection Check Sheet
< I n s p e c t i o n I t e m s >
ITEM Category NO Item Characteristics values Test means Record
1 Sensor cable
The cable must not be
flattened or twisted and
its covering must not be
damaged.
Visual check
2
Sensor cable
connector
The connector must be
connected securely,
and there must be no
play.
Visual check,
touch
3 Ready Lamp
The ready lamp must
not be flattened or
twisted and its covering
must not be damaged.
Visual check
4
Ready Lamp
Connector
The connector must be
connected securely.
Visual check,
touch
5 Firmware version - Visual check Ver
6 PLD code version - Visual check Ver
1 Imaging unit
7
Imaging unit IP
address
- Visual check
1 Connector
The connector must be
connected securely.
Visual check,
touch
2 Power box
2 Power switch
It must be possible to
set this switch to its ON
and OFF positions
properly.
Visual check,
touch
3
Control PC
1 Connector
The connector must be
connected securely.
Visual check
1 Startup
The system power must
come on when the
power of the control PC
is turned on..
Visual check
2 CCR startup
The system must start
up with no errors.
3 Status lamps
The lamps must provide
the correct indication
that corresponds to the
sensor statuses.
4
System connections
4 Shutdown
The system power must
go off when the power
of the control PC is
turned off.
1
X-ray generator
settings
The conditions under
which calibration is
implemented must be
noted..
Visual check
2
Preparation for
exposure
Phototimer must be
installed. Grid must not
be installed.
Visual check
5
Calibration
3
Calibration
processing
“Calibration completed
successfully.”
Visual check
6 Grid installation 1
Grid installation
angle check
Within ±1.0 degree Audit_grid.exe
7 Self-diagnosis 1 X-ray generator The conditions under Visual check
kV