70
my Home - control
This device is made in a 2 module DIN enclosure and a shallow enclosure
for Basic automation. The interface includes two independent control units,
identified with positions PL1 and PL2. The two units can send:
- controls to two actuators for two independent loads (ON, OFF or
adjustment) identified with the address PL1 and PL2 and mode specified in
M or;
- a control to the scenario module item F420;
- a double control intended for a single load (motor for rolling shutter UP-
DOWN, OPEN-CLOSE curtains) identified with the address PL1 and PL2 and
mode specified M.
The interface has one LED (two for interface item F428) to signal correct
operation and three cords (or terminals for interface item F428) to connect to
traditional devices such as:
- two traditional NO (normally open) and NC (normally closed) switches or
pushbuttons;
- a two-way switch.
Interface item F428 also has a pushbutton to enable the virtual configuration
while device item 3477 uses the keys connected to the cords.
BUS
side view
front view
configurator
housing
cords for connection to
traditional devices
configuration
two-input interface item f428 and item 3477
Interface item 3477
Interface item F428
configurator
housing
terminals for
connection to
traditional devices
LED
LED
key
