Bticino MH08CT/GB, Technical Manual

Page: 69 / 156

MY HOME cOntROL technical GUiDe
67
configurAtion
table
Function
Type of Position Position Position Position Position
control
A PL1/PF1 PL2/PF2 PL3/PF3 PL4/PF4
cyclical ON-OFF Light point 1 to 9 1 to 9 1 to 9 1 to 9 1 to 9
for short press in the room
+ adjustment (dimmer) indicated in R
cyclical ON-OFF Room 1 to 9 AMB AMB AMB AMB
control
2)
Rolling shutter Light point 1 to 9 1 to 9 1 to 9
up-down
1)
in the room 1 to 9 1 to 9
indicated in A 1 to 9 1 to 9
1 to 9 1 to 9
1 to 9 1 to 9
1 to 9 1 to 9
Monostable Room 1 to 9 M M
rolling shutter control
2)
M M
up-down
1)
M M
M M
M M
M M
Rolling shutter Room 1 to 9
up-down control 2)
to end of stroke
1)
ON control Room 1 to 9 ON ON ON ON
control 2)
OFF control Room 1 to 9 OFF OFF OFF OFF
control 2)
Example 1
If on the receiver positions PL2 and PL3 have configurator 7, the remote
control operates double actuator 7 of the room indicated in A, raising the
rolling shutters with pushbutton 2 and lowering them with pushbutton 3.
rear view
This mode lets the user associate generic controls (ON/OFF, UP/DOWN)
intended for single loads or double loads with the remote control keys.
The correspondence between the remote control keys and the loads
controlled is determined in the installation phase by the configuration of
positions A and PL 1 to PL 4 of the IR receiver, as shown in the table below.
The following can be associated with the remote control pushbuttons:
- Point-point controls, i.e. intended for single or double loads (rolling shutter
motor) whose address is specified by configurator 1 to 9 in positions PL 1
to PL 4. The various operating modes are determined by the association of
the configurators with the PL positions.
- Controls intended for actuators for single and double loads belonging to the
room defined with configurator 1 to 9 in position A. In this case the operating
modes are defined by the configurators marked by the graphics of the
function performed, inserted in positions PL 1 to 4.
addresses/
operating mode
definition of
channels 1 to 16 of
the remote control
Example 2
If on the receiver positions PL2 and PL3 have configurator and position A has
configurator 2, the remote control operates all the actuators in room 2, raising
the rolling shutters with pushbutton 2 and lowering them with pushbutton 3.
1) The two PL positions must have the same configurator. The UP control is associated
with the first PL position and the DOWN control with the second PL position.
2) The control is intended for devices belonging to the room indicated in A.
mode "A" (remote control) m = 1 to 4