72
my Home - control
Operating mode
The various functions performed by the configurator in position
M are listed
in the table below.
If
PL1 = PL2 two connected switches form a double control (two-way switch,
etc.).
PL1
A1
M
SPE
AUX
PL
A
L4651/2
M
SPE
AUX
PL
A
PL1
A1
A2
PL2
M
A3
PL3
L4652/3
L/N4681
PL
A
M
M
G1
G2
PL
A
L4671/1
M
G
PL
A
L4671/2
L/N4688
SPE
PL2
M
PL1
A1
SPE
PL2
M
position M
table
Possible function
Value configurator in
M
single function
double function
Cyclical ON-OFF for short press
no
—
and adjustment for long press
configurator
ON
ON
—
ON timed
1)
1 to 8
—
OFF
OFF
—
OFF pressing the key connected in PL1 or N2 (item F428)- ON pressing the key
—
O/I
connected in PL2 or N1 (item F428) and adjustment for long press (dimmer)
2)
Up-down rolling shutter to end of stroke
3)
—
Up-down rolling shutter monostable
3)
—
M
Pushbutton
PUL
—
2) As a function of the receiver actuator operating mode.
3) In this mode the grey cable corresponds to the up control while the white cable
corresponds to the down control.
NOTE: If circuits are connected to the interface terminals, the operating mode to
select is PUL.
If normally open (NO) pushbuttons are connected all the other operating modes
indicated in the table are performed.
1) The device sends an OFF control after a time set by the configurators used as
indicated in the table below.
Configurator
Time (minutes)
1
1
2
2
3
3
4
4
5
5
6
15
7
30 seconds
8
0.5 seconds
configurAtion
two-input interface item f428 and item 3477
commands to MH200
On configuring M = CEN SPE = 0 pushing a connected pushbutton sends a
command to MH200.
PL1 = PL2
Pressing pushbutton 1 sends MH200 a command with address
A – PL1 and
number
pushbutton 1, pressing pushbutton 2 sends MH200 a command with
address
A – PL1 and number pushbutton 2.
PL1 PL2
Pressing pushbutton 1 sends MH200 a command with address
A – PL1 and
number
pushbutton 1, pressing pushbutton 2 sends MH200 a command with
address
A – PL2 and number pushbutton 1.
