128
GENErAL ruLES FOr INSTALLATION
MY HOME - CONTrOL
GENErAL ruLES FOr INSTALLATION
T
SCS
Ethernet
12V
Reset
F452
392100
230Va.c.
E46ADCN
SCS
Ethernet
12V
Reset
F452
392100
230Va.c.
SCS
Ethernet
12V
Reset
F452
392100
230Va.c.
SCS
Ethernet
12V
Reset
F452
NO
OK
NO
NO
F452 INSTALLATION ruLES
BUS Automation
NOTE:
connect the Automation system power
supply item E46ADCn and the WEB Server
power supply item 392100 to a common
two-pole switch.
The Ethernet cable should
not be a crossover cable (pin to pin) if the WEB
Server is connected to an HUB. It should be a
crossover cable if the WEB
Server is connected directly (point-to-point) to a PC. If the correct cable is
used, the green LED of the device will flash (more or less fast) whenever
network traffic is detected.
During the first installation and whenever the setting of the WEB Server
needs to be modified, the PC serial port or USB must be used. The same
method must be used when uploading programming already saved in the
WEB Server and when updating firmware.
wArNINGS
• Installation and maintenance procedures shall be carried out by qualified
personnel only.
• Use insulated screwdrivers and do not touch the terminals to prevent
electrostatic discharges.
• Do not install the WEB Server near water (for example, laundries,
swimming pools, damp surfaces) or heat sources (radiators, stoves,
heaters).
• Do not install the device in particularly dusty places or in the presence of
corrosive vapours.
• Room temperature from +5° to +40°C, relative humidity ranging between
20% and 80%, non-condensating.
The WEB Server installation requires a connection:
- to the mains by means of a dedicated power supply item 346000 (for
item F452V) or item 392100 (for item F452);
- to the BUS of the burglar-alarm system (F453AV);
- to the BUS of the automation system (F452);
- to the 2 WIRE video door entry system/automation BUS (F453AV);
- to the 10BASET Ethernet communication network.
INSTALLATION ANd MAIN OpErATIONS
1. Carry out wiring operations as described below and in the following page.
2. Install the TiServer program (for item F452) or the TiF453AV program (for
item F453AV) on the PC which will be used for the configuration. The
PC should be connected to the WEB Server through a serial port or USB
(please see the TiF453AV or TiServer user manual).
3. Define the static (fixed) IP address of the WEB Server and the Subnet
Mask of the Ethernet network to which the device will be connected.
GENErAL ruLES FOr INSTALLATION
web Server item F452 and item F453AV
