53-1004106-15 Installation Guide
Brocade
®
X6-4 Director Hardware Installation Guide
Figure 21: Device Installed in Midmount Saddle
1. 10-32 screws with square-cone washers (6)
NOTE
For rails with round holes, use the clip nuts on the rack rails for securing 10-32 screws. For rails with square
holes, use the retainer nuts.
7. Reinstall the door.
Installing the 8U Chassis 27-31-Inch Rail Rack Kit for Four-Post Racks
Use the following instructions to install the device in a rack using the 8U Chassis 27-31 Inch Rail Rack Kit for Four-Post
Racks (XBR-DCX4S-0120).
Observe the following when mounting this device:
•
Use Electronic Industries Association (EIA) standard racks. Provide a space that is 8 rack units (8U) high, with a rail-to-
rail depth of 27-31 in.(68.58 to 78.74 cm). 1U is equal to 4.45 cm (1.75 in.).
•
Before mounting your device, review any specific installation and facility requirements in this Hardware Installation
Guide
•
Hardware devices illustrated in these procedures are only for reference and may not depict the device you are
installing into the rack.
Time and Items Required
Allow approximately one hour to unpack and install a device in a rack.
The following tools are required to install the 8U Chassis 27-31 Inch Rail Rack Kit for Four-Post Racks (XBR-
DCX4S-0120).
53-1004106-15
45
Summary of Contents for Brocade X6-4
Page 208: ......
