53-1004106-15 Installation Guide
Brocade
®
X6-4 Director Hardware Installation Guide
Assembling the Rack Hardware
Use the following instructions to install the rack mount kit illustrated in the previous figure into the equipment rack for
mounting the device.
1. On each rail (1 and 2 in the previous figure), loosen the four 10-32 screws on the adjustable brackets and adjust the
rails to the depth of your equipment rack. Tighten screws after adjustment.
2. Noting that the rails are designated "Left" and "Right," install each rail in the rack using four 10-32 x .63 in. or four
10-32 x .5 in. screws, two screws on each end of each rail. See the following figure.
•
Position the rails so that the adjustable ends are mounted on the intake aisle side of the rack.
•
For rails with round holes - use two 10-32 x .63 screws with square-cone washers on each end of the rail assembly.
Tighten the screws to a torque of 33.6 to 42 cm-kg (29.2 to 36.5 in.-lb).
•
For rails with square holes - use the two standard 10-32 x .5 in. screws with blue Loctite on the threads and
alignment washers on each end of the rail assembly. Tighten the screws to a torque of 33.6 to 42 cm-kg (29.2 to
36.5 in.-lb).
Figure 23: Device Rails Installed in Equipment Rack
1. 10-32 x .5 in. (1.27 cm) Phillips screw (for square holes) or 10-32 x .63 in. (1.60 cm) Phillips screw (for round
holes)
3. Install either clip nuts or retainer nuts depending on whether your rack has round holes or square holes.
These will allow you to secure the device to the rack uprights.
NOTE
For rails with round holes, use the clip nuts on the rack rails for securing 10-32 x .63 in. screws. For rails with
square holes, use the retainer nuts.
53-1004106-15
47
Summary of Contents for Brocade X6-4
Page 208: ......
