53-1004106-15 Installation Guide
Brocade
®
X6-4 Director Hardware Installation Guide
5. 10-32 clip nuts (for racks that have rails with round holes)
6. 10-32 retainer nuts (for racks that have rails with square holes)
7. Bracket adjusting screws
Assembling the Rack Hardware
1. Loosen the two 10-32 adjusting screws securing each midmount bracket to the saddle (see the previous figure) and
slide the brackets as far backward as possible.
2. Install the saddle to the equipment rack rails using the following steps while referring to the following figure.
a) Install the saddle to the port side of the rack rails using four 10-32 screws with square-cone washers, two screws
on each side of the saddle. Tighten the screws to 36.86 cm-kg (32 in.-lb).
b) Move the midmount brackets into position so they align with the rack mounting holes on the nonport side of the
rack. Secure the midmount brackets to the rack with four 10-32 screws with square-cone washers, two on each
side. Tighten the screws to 36.86 cm-kg (32 in.-lb).
c) Tighten the two 10-32 adjusting screws on each midmount bracket.
NOTE
The following figure shows the saddle for XBR-DCX4S-0126. The saddle for XBR-X64-0126 has a
somewhat different design but installs the same way.
Figure 17: Saddle Installed in a Rack
1. Saddle
2. 10-32 screws with square-cone washers
3. Adjusting screws (two on each side of the saddle)
53-1004106-15
41
Summary of Contents for Brocade X6-4
Page 208: ......
