53-1004106-15 Installation Guide
Brocade
®
X6-4 Director Hardware Installation Guide
3. Install the shelf saddle to the nonport side of the rack shown in the following figure. Install the saddle in the same
vertical location as where the shelf installs on the port side of the rack. In using the previous figure as an example, if
the shelf is installed in location 23 on the port side, install the saddle in location 23 on the nonport side. Ensure that the
words "THIS SIDE UP" on the saddle face towards the port side of the rack (see the following figure).
Secure the saddle to the rack using four 10-32 screws with washers, two screws on each side of the saddle. Tighten
the screws according to specifications under
.
Figure 5: Installing Saddle to Equipment Rack
1. Shelf saddle
2. 10-32 x .5 in. (1.27 cm) Phillips screw with blue Loctite on threads or 10-32 x .63 in. (1.60 cm) Phillips screw
with square cone washer for racks that have rails with round holes
NOTE
For rails with round holes, use the clip nuts on the rails for securing 10-32 screws. For rails with square
holes, use the retainer nuts.
53-1004106-15
29
Summary of Contents for Brocade X6-4
Page 208: ......
